IF-BOARD.DP-GEN2

Überblick

This is the galvanic isolated and CE certified .dp InterfaceGen2, which is used to set parameters and protection behavior for digital power products. It can be used to either test parameter temporarily or to burn them permanently. The .dp device will be connected via USB to a computer and is controlled using the .dp Vision Software.

Summary of features

  • .dp Interface Gen2 for parameterization of .dp products via .dp vision
  • Safe and galvanic isolation from DP2x board to low voltage side (USB)
  • Startup sequence and VCC supply voltage for DP2x is generated on the .dp Interface Board Gen2
  • Short circuit detection on VCC
  • Status LEDs for power, sync and PC connection
  • CE certified
  • Easily adaptable to specific application boards via standard 8-pin (2x4 pins) connector @Interface board
  • Firmware of the .dp Interface Board Gen2 can be updated via USB

Summary of benefits

  • Comfortable parameter setting without changing components on hardware
  • Maximum flexibility for adapting application behavior via parameters
  • Optimize system performance
  • Reduced R&D efforts
Videos
Share
Share
Support